Three factors must be borne in mind when evaluating a particular synthetic plan. The first is cost—of far greater importance in industrial, large-scale synthesis than in laboratory work in which a particular synthesis may be carried out only once, as in the total synthesis of a naturally occurring compound, and which in any case is likely to be on a relatively small scale. The environmental impact of chemical syntheses has become an important consideration. Syntheses or processes that have a benign environmental impact, whether by use of safe and commonly available reagents or by minimization of environmentally harmful waste products, have become an essential feature of so-called “green chemistry.”
Second, the yield in each step must be considered. A step in a synthesis may give a very low yield of the desired product. For example, a proportion of the reactant may be converted into a different product by an alternative process that competes with the desired one; some of the product may undergo a subsequent reaction; or some of the product may be lost in the separation processes required for its isolation in a pure state. The yield is usually defined, on a percentage basis, as the number of molecules of product obtained when 100 could in principle have been formed. A yield of about 80 percent or more is generally considered good, but some transformations can prove so difficult to achieve that even a yield of 10 or 20 percent may have to be accepted. The ultimate synthetic goal in a perfect synthesis is to achieve 100 percent “atom efficiency,” in which all atoms of all reagents are incorporated into the synthesized product without the formation of any by-products.
Naturally, the yield of a process affects the cost of the product, because the shortfall from a 100 percent yield represents wasted material. In addition, yield can be of the utmost importance in determining whether a synthesis is a practicable possibility, because the overall yield of a synthesis is the product of the yields of the individual steps. If these intermediate yields are mostly low, the ultimate product may not be obtainable in the necessary amount from the available starting material.
Finally, consideration must be given to the rate at which each step in the planned sequence occurs. In many instances, a desired reaction is possible in principle but in practice takes place so slowly as to be ineffective. It is then necessary to investigate whether the rate can be increased to a practicable level by altering the conditions of the reaction—for example, by raising the temperature or by adding an extra species, called a catalyst, that increases the rate without altering the course of the reaction.
Leave a Reply